2 Comments

1. 

   Daniel M Garcia on 2020-12-12 at 7:52 pm

   Looks really nice. Is the Raspberry Pi 4 built into the front panel? does it have room for the Raspberry pi to have a fan? Room for a 60mm noctua fan would work well to keep it cool. may be have it getting fresh air from the holes on the right. Is the power supply getting fresh air – or are you using that heat to warm the camber. Maybe have an inlet to pull fresh air into the power supply from outside and warms air into the camber and will keep the power supply healthy. having an area to add a thermometer to show internal temp of camber and external temp would be nice.

   Also it would be nice to include the fusion 360 files so we could make some modifications to suit our needs.

   I really excited to get my hands on your enclosure.

   Reply
   • 

     Julien on 2020-12-13 at 12:05 pm

     Hi Daniel,
     Yes I did the design with the raspberry PI 4. I will do also the design for raspberry PI b+
     I did the design for a 40mm fan that feed raspberry with fresh air.
     Air go inside from the air vent on the left of the screen and of inside out of air vent on the right.
     For the power supply there is dedicated hole in the enclosure to get directly fresh air from outside.
     About the thermometer, I plan to use raspberry with DHT sensor but I will also design with a classic thermometer.

     Reply